Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - kdziok

Pages: [1]
1
Ingredients / Re: Post your water report
« on: November 05, 2012, 08:08:11 pm »
Attleboro, MA
8/14/2012
Ward Labs Analysis
pH    7.6
Total Dissolved Solids (TDS) Est, ppm    225
Electrical Conductivity, mmho/cm    0.38
Cations / Anions, me/L    3.3/3.2
Sodium, Na    58
Potassium, K    2
Calcium, Ca    11
Magnesium, Mg    2
Total Hardness, CaCO3    36
Nitrate, NO3-N    0.1 (SAFE)
Sulfate, SO4-S    2
Chloride, Cl    77
Carbonate, CO3   < 1
Bicarbonate, HCO3    53
Total Alkalinity, CaCO3    44

2
Yeast and Fermentation / Re: RIS Yeast Recommendations
« on: November 05, 2012, 07:58:23 pm »
Awesome, thanks so much for all of the suggestions!!! The recipe that I'm toying with is coming in with a projected OG of 1.090 and ABV of 9.3 so it's not too much of a bomb. I think I may go with the 007 on this first attempt. I used it once before on an amber-ish ale a while back and was really happy with the results. Thanks again for all the suggestions!!!

3
Yeast and Fermentation / RIS Yeast Recommendations
« on: November 04, 2012, 10:07:15 pm »
Hey all! I'm planning on doing my first Russian Imperial Stout this winter and wanted to get some yeast recommendations/input. I was originally looking at using the WLP-004 strain but after doing more digging, it looks like people are using lots of different yeasts like chico and english ale strains too. I know alcohol tolerance is a factor but I guess there have been many successes pushing the envelope of non-traditional strains. Anyone have a favorite they always reach for when doing a RIS? Looking to make something along the lines of a Stone RIS or Parabola. Thanks!

4
All Grain Brewing / Re: Brewing Water Adjustments
« on: November 01, 2012, 10:28:49 am »
Thanks for the reply and I'm glad the additions were ok! I had the water tested by Ward before I started playing with the adjustments so I could have a good baseline. I'll just leave it to do it's thing and see how it turns out once it's bottled up and conditioned. I just wanted to make sure there wasn't something way out of whack!

Thanks again for your help!!!
Cheers!

5
All Grain Brewing / Brewing Water Adjustments
« on: November 01, 2012, 08:23:53 am »
Hey all! I've just begun venturing into the world of water adjustments and I'm not sure if I made my calculations correctly. After the 4+ hours of BN's Waterganza, tons of articles and JP's How to Brew info, I thought I had a good enough grasp on it. After tasting my beer last night out of secondary has me second guessing though. The beer was super bitter (even for a DIPA) and almost had a mild salty vibe to it. It's not horrible, just really caught me of guard! If anyone has a free sec, could someone look over my water and salt adjustment numbers to see if there are any red flags or maybe make some recommendations? I'd be eternally grateful!!!

Below is a screen shot of the additions. The 5.3gal addition was for the mash and the 5.0gal addition went into the kettle after the sparge. Also the hop additions for a 90 min boil were 1oz Galaxy (14.8alpha) @ FWH, 20, 10, 5, FO so it's not too over the top! Any insight is greatly appreciated!

THANK YOU SO MUCH!!!!
-Ken


Pages: [1]