My buddy gave me a Nostalgia Electrics Kegerator since he is upgrading his setup. After plugging it in i found out that the temperature doesnt get the beer colder than 45'F. I decided to start adjusting the thermostat that was located in the back. I found the adjustment screw on the face of the thermostat and fiddled with it over the course of 4 days. I got it down to the point of freezing which is obviosuly to cold. As i went to adjust the screw again, it just fell out. Inside the thermostat you can see a spring hanging in there (screw orginally went through the middle tighting and loosing the spring). I tried real quick to screw it back in, but it seems like it cant reach the recieving end. Is there a way to get this screw back in, or am I fudged? I only spent like 5 minutes on it before i had to leave for work. Any advice would help.
ps. compressor, fridge everything still works as i believe the thermostat does too, just needs the screw again so i can adjus the temp