General Category > Equipment and Software

False bottom hole size

(1/1)

johnny_b:
Hello All,
I am considering fabricating a square false bottom for my mash tun. I have acquired a sheet of perforated 304 stainless with .125" diameter holes. Will these holes be too big for the bottom of the mash tun?

Any input is greatly appreciated.

lonnie mac:
Humm, this seems rather large actually... Mine, and most you would purchase at a HBS will be 3/32 perforated holes on 5/32 centers...

With this, I still get goobers passing though, and I don't really crush unusually fine.

tom:
0.125" = 4/32"
What is the spacing?

johnny_b:
The spacing is .1875" (3/16") on center, or .0625" (1/16") between.

Thanks.

Navigation

[0] Message Index