Homebrewers Association | AHA Forum
General Category => Equipment and Software => Topic started by: In The Sand on July 09, 2013, 01:13:35 AM
-
I'm looking at getting a short run of sight gauge glass to go from my O2 injection, to ball valve, to fermentor. This (http://www.mcmaster.com/#gauge-glass/=njeovy) is the sight glass I'm looking at. What fittings do I need to buy to go from the O2 (which is stainless steel, 1/2" FPT) to the sight glass and back to a stainless ball valve?
-
And I don't wanna spend the $120 on the one they have on their site.
-
Seems you could use some stainless compression fittings. It might work better with a section of polycarbonate. Compression fittings can be pricey.
Sent from my SCH-I535 using Tapatalk 4 Beta