Homebrewers Association | AHA Forum
General Category => Equipment and Software => Topic started by: blatz on December 18, 2009, 08:58:31 am
-
anyone know the mcmaster carr part no. for these?
http://www.micromatic.com/draft-keg-bee ... 0-17Q.html
want to buy a few
-
Link is broken :(
-
danke.
http://www.micromatic.com/draft-keg-beer/regulators-parts-pid-440-17Q.html
-
May be a silly question but why you do not want to buy it from Macromatic?
They have FL distribution.
They are not providing a lot of info to search on if looking somewhere else.
Part # is most likely their part number.
So what you have left is:
"Quad Ring Inlet Seal" and
"Stem Quad Ring"
No dimensions thou.
-
reason why is that is the ONLY thing I need from micromatic at the moment thus it will cost me $6 in shipping +tax, whereas I need a few things from McMaster Carr already, which would substantially cut down the shipping cost.
-
Can you measure the old one and cross it by size here?
http://www.mcmaster.com/#o-ring-seals/=4zrori (http://www.mcmaster.com/#o-ring-seals/=4zrori)
-
Where is that O-ring used? Between the regulator and tank?
-
yeah - it is inlaid in the stem that connects the regulator to the tank.
the only one I have right now is in use, so I'll have to wait until my tank kicks to take a measurement.
my other regulators all use the nylon disc.
-
Do not you get new washer when you exchange your tank?