Homebrewers Association | AHA Forum
General Category => Equipment and Software => Topic started by: phillamb168 on August 01, 2011, 12:07:40 PM
-
For about two weeks. When I pulled them out they were slippery to the touch, and after "drying" they're now quite sticky. Have I ruined them completely? I thought StarSan was OK with plastic?
-
It's just the soap from StarSan. You can rinse them off with water or soak them in some fresh StarSan.
No damage done.
Cheers
-
I did wash them off, and they're still a bit tacky.
-
Let them sit out for a few weeks.
They will harden again.
And do not do it again ;)
-
Let them sit out for a few weeks.
They will harden again.
And do not do it again ;)
Is this the plastic connects? Dude just buy some new ones.
-
I've had the same thing happen with the line, and I've found it always stays pretty tacky. Maybe I just don't wash it well enough. I just replace the line, and don't do it again. Until next time I do it. ;)
-
Ok, ok, I'll replace them. Durn it.
-
Wait, this is the connectors or the line? For connectors I would try soaking them in a variety of things to see if they would come clean. Maybe vinegar would help take the stuff off? It's worth a try. For line, I would just replace it.