Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - ocddot

Pages: [1]
Equipment and Software / Re: Punching powder coated steel?
« on: September 01, 2015, 07:19:04 PM »
I would cover the punch area with tape to prevent the coating from chipping. Not sure if that's a solution, but its what i would try do to remedy the chipping

General Homebrew Discussion / dry hop pellicle
« on: June 30, 2015, 08:40:15 PM »
I have noticed that when ever I dry hop a pellicle forms atop the beer in the secondary. Is this normal? Is it an infection? I don't notice any off flavors or funk.

Zymurgy / Re: Kumquat Wheat/Kolsch Recipe
« on: April 24, 2015, 01:44:42 PM »
What category is the kumquat wheat ale? I brewed the kumquat wheat ale and want to enter it into my local fair homebrew competition.

Equipment and Software / Re: Conicals
« on: April 14, 2015, 06:09:22 PM »
To all the owners of conical,

What method of temperature control is used? I want to buy a conical, but I am not sure of the best way to controls temps.

Ask the Experts / Re: Ask the Experts: Gordon Strong
« on: November 22, 2013, 02:56:40 AM »
Hello Gordon,
   Last december (12/5/12)  i made a 17% braggot, its been aging a year in the secondary. Its come time to bottling, and  i really want to bottle condition it. How should i go about it?
   fyi-my friends said to force carb and bottle.



Equipment and Software / Re: how to connect to natural gas
« on: August 22, 2013, 06:10:38 PM »
will 1/2" pipe be large enough to handle to burners?

Equipment and Software / how to connect to natural gas
« on: August 22, 2013, 01:04:35 AM »
I want to switch over to natural gas from propane. My brewstand is about 25ft from the nearest gas line.  Any one have any ideas how i connect my brew stand to the natural gas line? is their a hose i could get? I figure i could connect a it with hard pipe with a flex line on both ends, but i would prefer to use a hoe foe the entire length, so  i could roll it up. any ideas?

after my second batch of extract.

Kegging and Bottling / Re: Bottle Labels
« on: April 09, 2013, 04:53:51 PM »
i use blue painters tape or write a code atop the bottle cap.

Extract/Partial Mash Brewing / Re: Why does all my beer taste the same?
« on: February 05, 2013, 03:27:15 PM »
What yeast are you using?

Pages: [1]