Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - rb30022

Pages: [1]
1
General Homebrew Discussion / Using Starsan in Copper Counterflow Chiller
« on: December 27, 2016, 03:36:43 PM »
I use Star San as my sanitizer of choice.  I recently purchased a copper counterflow wort chiller and added it to my system.  After using it for the first time, I flushed it with hot water and then ran Star San through it.  I decided to leave it full of Star San to prevent anything from growing inside between brews.  A few weeks later, I was reading an article on cleaning and sanitizing and was reminded that Star San is an acid and that it reacts with copper.  I removed the hose from the bottom of my chiller and allowed it to drain and, sure enough, it has a green coating on the inside.  I have a couple of questions regarding what damage I may have done.

1.  Is the green stuff inside my chiller harmful to humans and, if so, how should I go about removing it?

2.  Have I done any permanent damage to my chiller such as pitting that might allow bacterial places to hide?

Thanks for any help or suggestions.

2
Equipment and Software / Fermentation Immersion Chiller
« on: September 25, 2012, 01:31:04 AM »
Does anyone have experience with an immersion chiller for fermentation.  I ferment in a 25 gallon conical and would like to be able to control fermentation temperature.  I thought about building a cabinet of some sort but I barely have enough time to brew and am reluctant to take on a project that large.  I also thought about an upright freezer with a controller but it is hard to find one larger enough for my fermenter.  Then it occurred to me that an immersion chiller might be an option.  I've seen a couple of references to such a device but have lots of questions.

Should I use stainless or copper tubing?
What length of tubing do I need and what diameter?
Would a flat spiral design be better or should I go with a traditional cylindrical coil?  Must be able to clean and sanitize.
Would an ice bath in a cooler be sufficient or should I place the "hot" coil in a chest freezer or refrigerator?

If anyone could offer any advice, I would really appreciate it.

3
I have constructed a keg cabinet as part of my bar in my basement and am trying to figure out how much refrigeration I need to keep my kegs cool. The cabinet measures 27" H x 40" W x 24" D and has 1.5" of pink Styrofoam insulation board on all sides. I read Chris Bible's article in this month's BYO and calculated that I need about 400 BTU/Hr to keep the interior at about 35 deg F with an exterior temperature of about 75 deg F but this seems like a low number. Can anyone tell me if this value is in the right ball park? Also, I am trying to decide whether to use conventional refrigeration or thermoelectric. For conventional, I am looking at a remote condenser unit off to the side with an evaporator inside the cabinet. A thermoelectric unit could be mounted directly to the side of the cabinet. Any thoughts on pros and cons of each type of system?  Can anyone suggest a unit that can provide the level of cooling that I need at the above temperatures.

Thanks.

Pages: [1]