Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - craigevo

Pages: [1]
1
Equipment and Software / Re: How's your Thermapen?
« on: November 09, 2012, 03:02:54 AM »
Does anyone else have a 'sticking point' with their thermapen ?

Mine has always had one - open the probe about 100 degrees and it comes on, keep opening it and it goes off at about 150. Keep opening and it goes back on again at about 170.

bit annoying but I live with it. seems to help if i 'excercise' the probe by opening fully and closing a few times. its always been like this.

Anyone ever opened one up? I would like to see if theres anything obviously wrong, but not sure if it will be difficult to put back together again afterwards.

2
Yeast and Fermentation / Re: Pilsner Will it Blow?
« on: October 01, 2012, 09:09:05 PM »
Does anyone know how much yeast is sufficient for krausening if your trying to reduce diacetyl ? (I'm not concerned with carbonating the beer at this stage)

I cant seem to find a patching rate estimate for this. I have heard "make a starter" but I have also heard "we are not trying to get yeast growth". Both true I suppose, but still, how much yeast is needed to do this clean up operation ? 100 billion cells (one fresh pack) per 5 gallons ? and is this assuming no growth in the starter ?

3
General Homebrew Discussion / Re: That German lager flavor
« on: September 17, 2012, 01:44:55 AM »
Martin, when you say make sure your wort pH in the kettle ends up in the 5.3 to 5.4 range when measured at room temperature...

Do you mean pH at the start of the boil or end of the boil ?

Pages: [1]