Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - zombywoof

Pages: [1]
CO / Erie - Indian Peaks Alers
« on: October 13, 2011, 03:03:16 PM »
Where - 1370 Washburn St. (Erie Village) Erie CO 80516
Who - Mark & Angela Spaulding C/O Indian Peaks Alers out of Longmont
When - 11/5 Mash in/Start 11am to  ???
Brewing - Club Xmas Brew - Amber Oatmeal Cookie Planning to brew both Extract and All Grain batches - Multiple systems
Contact -

All welcome, good chance to see different types of brewing with experienced brewers.

Good idea to bring something you like to drink or some homebrew to share

Yeast and Fermentation / Re: oxygenation tips
« on: August 10, 2010, 12:41:45 PM »
1vertical, how long do you typically "gas" the wort? I typically go anywhere from 60 sec to 80 sec. I've heard you can go into several minutes for big beers.

Yeast and Fermentation / Re: oxygenation tips
« on: August 03, 2010, 12:27:50 PM »
The beers have been fine, so I may have overstated the temp a wee bit!  This summer has been hot and my chiller only gets it down to those temps, by the time I get it into the carboy and get my self together it's probably closer to 70 - 73, not sure. Guess I should actually check next batch. I could wait longer in my basement which is cooler.

Yeast and Fermentation / Re: oxygenation tips
« on: August 03, 2010, 12:09:30 PM »
I typically pitch between 75 and 80 degrees. I use a stone with those red oxy bottles you get from HD. I have read many different opinions on how long to oxygenate, some based on temp, some based on OG, etc.. Most of my beers tend toward the higher OG range. I have been increasing the time of late because I don't seem to get as far along in fermentation as I think I should. Is there a "Too Much" when using a stone? Is there a "Rule of Thumb"?

Pages: [1]