Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - yeastmaster

Pages: [1] 2 3 ... 10
1
Yeast and Fermentation / Re: Dry yeast for Oktoberfest/Marzen?
« on: July 06, 2017, 10:32:44 PM »
I think the M76 would work well. It's Bavarian, though, not Bohemian. Just sayin' :)

Oops!  ::)

2
Yeast and Fermentation / Dry yeast for Oktoberfest/Marzen?
« on: July 06, 2017, 05:05:11 PM »
I am thinking about brewing a Marzen/Oktoberfest in the near future.  My access to liquid yeast is pretty limited and I can't get a hold of any White Labs or WYEAST lager yeast right now.  There is a selection of dry yeast in town.  I was wondering if anyone had any favorite dry yeasts for this style?  I was thinking about the Mangrove Jack's M76 Bohemian Lager but am open to any other suggestions.  Thanks!

3
Beer Recipes / Sweet stout recipe formulation?
« on: November 05, 2016, 08:01:54 PM »
I'm looking to brew a sweet/milk stout but have never done one before.  I've had pretty good success with doing a dry stout with maris otter, roasted barley, flaked barley, chocolate malt and black malt.  How should a sweet stout recipe be different from a dry stout recipe.  I was planning on adding lactose but wasn't sure how much to add?  Would adding in a crystal malt be helpful and if so what lovibond?  What about honeymalt?

Thanks!

4
General Homebrew Discussion / Re: Mouse in the blowoff bucket
« on: October 24, 2016, 12:39:03 PM »
I am brewing an IPA and due to a large amount of foam at the start was using a blow off tube and bucket.  When the foam died down I switched from the tube to a standard air lock.  While dumping the bucket I noticed a mouse had smelled the sugars in the foam crawled up to investigate and fallen in to the bucket.  It has been an exmouse for a number of days.  The scientist in me says proceed - the airlock should keep out any mouse extract.  The twelve year old girl in me says EWWWWW.....   :P  Thoughts??

I hear if you bring the mouse to the Elsinore Brewery you can get free beer!  ;D

5
Other Fermentables / Re: Back Sweetening mead?
« on: September 21, 2016, 03:03:20 PM »
Potassium metasulfite (Camden tablets) stop fermentation and potassium sorbate prevents it from restarting. There are plenty places on the internet with procedures. Make sure you tell anyone who drinks it it contains sulfites as some people have reactions.

If fermentation is done can I just skip the camden tabs and just use the potassium sorbate?

6
Other Fermentables / Back Sweetening mead?
« on: September 21, 2016, 12:08:45 AM »
I have a mead that has finished out pretty dry.  I would like to back sweeten it before bottling but have never done this.  What do I need to add to stop refermentation of any honey I add?

7
Other Fermentables / Advice for yeast and honey amounts for mead
« on: December 10, 2015, 02:48:07 PM »
I am planning on making two 5 gallon batches of mead sometime in the near future.  I'd like to try two different yeasts.  I believe last time I did a mead I used 12# honey and D47 yeast and it came out very dry.  This time I would like to have a sweet and a semi-sweet or dry mead.  Does anyone have any recommendations for yeasts  and honey amounts (I have a large supply right now).  The last time I made a sweet mead I used Wyeast 4184 Sweet Mead and it came out overly sweet (can't remember how much honey I used and it may have fermented cold), is that typically a problem with this yeast?

Thanks

8
Equipment and Software / Re: Promash Status
« on: November 27, 2015, 01:57:45 AM »
I finally switched to BeerSmith a couple of years ago.  It took me some time to get used to it but I really like it now.  I like being able to use the phone app during my actual brewing.  I didn't realize that Promash worked on the newer operating systems.  I used to run it on a laptop with XP.  When I upgraded that laptop I couldn't install promash because I have it on old floppy discs and no longer have a drive for those.  If it ever does get re-released I'd love to give it a try again

9
Equipment and Software / Replacing burner on my old Camp Chef?
« on: November 27, 2015, 01:53:05 AM »
I have a Camp Chef burner and the burner is getting rusty and not burning well.  It needs to be replaced.  The current burner used by Camp Chef is rated at 60K BTU (my original is listed as 70K).  The only problem is that the shipping to me in Alaska is more than the cost of the burner.  I found the Bayou Classic BG10 burner on Amazon which I can get with prime shipping.  Does anyone know if this can be used/fit in the Cam Chef frame?  It looks like it is rated for 150K BTU, can the Camp Chef frame handle this?

Thanks

10
you could convert your 10 gallon to a hot liquor tank and run a HERMS coil in that. Your mash would rest while you stop the pump and heat the water to sparge temp.

I frequently am brewing outside in well below zero temps.  I am planning to have my pump and as much of my lines in an insulated box.  I mash in a cooler and plan to build a 2 inch foam cover or sleeve to go over it.  I think it will be easier for me to put together a herms tube that is inside my insulated (and potentially heated) box vs maintaining a kettle at temp for an extended period of time. 

Of course if I would just build a space where I could brew indoors that would solve some problems......Tend to burn a lot of propane when it is 20 below!

11
I'm planning on sticking primarily with propane but would like to add a rims tube to the mash system so I can better regulate mash temps.  Eventually I might go all electric but I don't have a convenient 220 outlet where I brew right now.

12
I'm in the process of upgrading my system.  I currently have a 10 gal kettle with propane and a large cooler for doing infusion mashes and have used that for years.  I now have a 19 gallon kettle and a couple of kegs to play with along with a pump.  I'd like to start having more control over my mashes and was thinking a RIMS setup would work well for me.  I was wondering if anyone can point me in the right direction for instructions or plans on building a RIMS tube?  I also envision eventually building this out for some automation and would like to know where to get started on getting information for electronics for temperature control, etc.

Thanks!

13
Ingredients / Cacao Nibs in a porter?
« on: August 17, 2014, 10:49:17 PM »
What do folks recommend for using cacao nibs in a porter?  Boil?  Fermenter?  Keg?  Planning on doing a porter tomorrow and got a hold of some nibs today and not sure how best to use them.  Thanks!

14
All Grain Brewing / Re: cold-weather brewing
« on: March 05, 2014, 06:50:47 PM »
I brew in Fairbanks, Alaska, lots of cold weather brewing up here.  Winter is my biggest brewing season because in the summer there is so much other stuff to do it can be hard to find time to brew.  I boil and heat water outside.  I do an infusion mash in a cooler.  I usually carry the hot water inside and mash inside.  I sparge indoors and carry my wort back outside to boil.  After boil I bring the whole batch back in for chilling (37 degree well water  ;D).  I have no problem keeping my boil going at 20 or 25 below temperatures although I do blow through a lot more propane.  The only time I've run into issues with my propane was this winter when I was doing a Barleywine and was doing a 2 hour boil.  The propane tank started to freeze up and I had to swap it out for the one on the grill.

I've got the stainless to start doing 10 or 15 gallon batches but the way I have to carry all those hot liquids around 5 gallon batches are my limit.  I think I'm going to get my large system running for summer brewing.  I have some ideas for enclosing my brew space and getting a portable heater so I can do those large batches outside during the winter but haven't followed through on them yet.....

15
Yeast and Fermentation / Re: Dry Yeast for English Style Barleywine?
« on: January 01, 2014, 05:18:11 PM »
Well I ended up going with S-04.  I ended up pitching 3 packs into my wort with an OG of 1.100 (a couple of the packs were old so I wanted to make sure I had good viable yeast).  Took it from 1.100 to 1.018 in 7 days!  Tasting a little hot right now but I imagine that will mellow with age.  Tastes like good barleywine underneath the alcohol heat.

Pages: [1] 2 3 ... 10