Good to see you on here Joe!
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
When I turned 21 (all so many years ago) I was given a "Beer In A Bag". Just add hot water. I don't recall if there was a yeast packet or not. Shake, store, serve. For what it was I remember it not being too bad. The first third was nicely carbonated and the rest just went down hill from there.Ha... This is how I started out too, about 20 years ago. The results were terrible, but the science of it all was intriguing enough to have me hooked.
I must say that it gave me the start to home brewing. It just took me a few years to jump all in.
Diagonal cutting pliers. But I bet a Dremel would be just as easy.The universals I have are pretty tall, so on some of my kegs, it's tough to push the disconnect on. Trimming a coil or two off the spring is an easy fix.This is exactly what I've read about them. How do you trim them? Dremel?