Well, after saving my pennies, I am having part two of the labor end of the Brew Stand 3.1 update performed today. That's right. Automation. Last month, my stand went back to the welder to have a burner support and windscreen added for the mash tun. Last week, I ordered two Blichmann Tower of Power control modules (I'm no electrician). Today, I dropped the stand off at the plumber to adjust the gas piping to accommodate the mash tun burner and install the asco valves while they are in there. Over the next week, I'll be installing the sparkers for the mash tun and HLT burners. I'll also be installing a mount for the TOP, which basically amounts my bolting an articulating wall mount for a tube TV to the stand.
I know this isn't DIY. But, in large part, this stand never has been. Pictures to follow.