General Category > All Grain Brewing

5-gallon vs. 10-gallon cooler?

<< < (11/11)

Wort-H.O.G.:

--- Quote from: fmader on February 26, 2013, 06:56:00 PM ---
--- Quote from: wort-h.o.g. on February 26, 2013, 06:33:32 PM ---

--- End quote ---

Very nice set up. Obviously it is very close to my set up that I posted above. Do you have issues getting the inside of your copper clean of debris with it all soldered together. I take mine apart after every mash to wash and can be a pain to put back together. I was just wondering what you do, because I may certainly consider soldering mine.

--- End quote ---

May be hard to see, but if you look in the middle at the T's, it's not soldered there, allowing you to pull apart into three sections. Rinsing is a snap that way and I rinse after each mash.

fmader:
Got it! This is a very solid design....I too pull just about all the wort through. There is minimal, if any, dead space with this design and would recommend it for anybody.

Navigation

[0] Message Index

[*] Previous page

Go to full version