Author Topic: Can't find leak in regulator  (Read 864 times)

Offline kramerog

  • Brewmaster
  • *****
  • Posts: 784
    • View Profile
Can't find leak in regulator
« on: November 29, 2012, 12:32:25 PM »
If I open and shut my CO2 bottle really quick with the valve downstream of the regulator closed, the dispense gauge will shoot up to 15 psi or whatever my dispense pressure is and over then minute or so the pressure will drop to zero.  I've squirted Star San solution over various fittings of the regulator but can't find a leak.  What's my next step?
« Last Edit: November 29, 2012, 12:51:58 PM by kramerog »
Brewers of South Suburbia
Brixie's Brewers
Oak Park Homebrewers

Offline mtnrockhopper

  • I spend way too much time on the AHA forum
  • ********
  • Posts: 2878
  • Delaware
    • View Profile
Re: Can't find leak in regulator
« Reply #1 on: November 29, 2012, 12:41:51 PM »
How tightly is the regulator attached to the tank? Did you use a wrench? 
 
Is there a gasket between the regulator and tank? Some regulators have a nylon gasket attached, others need a separate gasket, but it shouldn't be metal/metal.
 
 
Jimmy K

Delmarva United Homebrewers - President by inverse coup when the old president ousted himself.
AHA Member since 2006
BJCP: B0958

Offline Slowbrew

  • Senior Brewmaster
  • ******
  • Posts: 1657
  • The Slowly Losing IT Brewery in Urbandale, IA
    • View Profile
Re: Can't find leak in regulator
« Reply #2 on: November 29, 2012, 12:44:36 PM »
How much do you trust the valve?  It may be bleeding through the downstream valve and the regulator is okay.

Paul
Where the heck are we going?  And what's with this hand basket?

Online Pinski

  • Senior Brewmaster
  • ******
  • Posts: 1563
  • Portland, Oregon
    • View Profile
Re: Can't find leak in regulator
« Reply #3 on: November 29, 2012, 01:24:36 PM »
How much do you trust the valve?  It may be bleeding through the downstream valve and the regulator is okay.

Paul

+1
Dip that downstream valve in some StarSan
Thank you BEER!

Offline kramerog

  • Brewmaster
  • *****
  • Posts: 784
    • View Profile
Leak is fixed!
« Reply #4 on: March 05, 2013, 08:35:47 PM »
Following advice of a homebrewer at Praxair, I tightened a nut in the middle of the valve handle with a manual nut driver (if that is the right term, it looks like a screw driver) so I would avoid overtorquing it.  That sealed the leak.  I think the nut tightens the packing around the valve stem.  I think the leaky stem may have allowed some air in the gas line which caused my kegged beers to age really fast.
Brewers of South Suburbia
Brixie's Brewers
Oak Park Homebrewers