General Category > All Grain Brewing

Lid on partially?

<< < (4/4)

HoosierBrew:

--- Quote from: ynotbrusum on April 03, 2013, 11:21:47 AM ---
--- Quote from: HoosierBrew on April 03, 2013, 07:22:51 AM ---+1.  AFAIC anyway.

--- End quote ---

Not that I'm any good with these acronyms, but I think it is "AFAIK" - FWIW.  Very funny stuff, though, guys.

The DMS can get out as long as it is vented to a reasonable degree, so RDWHAHB or whatever you have available.  Still chuckling....

--- End quote ---
   FWIW - I meant "As far as I'm concerned", hence AFAIC. LOL, RDWHAHB !

theDarkSide:
AFLAC!!!!

ynotbrusum:

--- Quote from: HoosierBrew on April 03, 2013, 11:28:11 AM ---
--- Quote from: ynotbrusum on April 03, 2013, 11:21:47 AM ---
--- Quote from: HoosierBrew on April 03, 2013, 07:22:51 AM ---+1.  AFAIC anyway.

--- End quote ---

Not that I'm any good with these acronyms, but I think it is "AFAIK" - FWIW.  Very funny stuff, though, guys.

The DMS can get out as long as it is vented to a reasonable degree, so RDWHAHB or whatever you have available.  Still chuckling....

--- End quote ---
   FWIW - I meant "As far as I'm concerned", hence AFAIC. LOL, RDWHAHB !

--- End quote ---

Gotcha - I stand corrected (ISC).

industrialpunk:

--- Quote from: reverseapachemaster on April 02, 2013, 09:18:50 AM ---If you think DMS will be an issue leaving the lid on partially take a look at almost every commercial system and see how it is entirely covered except for the part where the chimney is.

--- End quote ---

They also have kettles designed to keep condensation from dripping back into the boil.

Navigation

[0] Message Index

[*] Previous page

Go to full version