Author Topic: recommended Settings for a digital therm controller  (Read 996 times)

Offline passlaku

  • Assistant Brewer
  • ***
  • Posts: 183
    • View Profile
recommended Settings for a digital therm controller
« on: June 05, 2013, 07:55:47 AM »
I was using an analog therm controller but based on recommendations from a previous thread here I upgraded to digital - in hopes of making my new chest freezer last a long time.  I am using it in a serving freezer and was wondering what you guys recommend in terms of settings.

SP - set mine to 42
Dif - 3
ASD - 10
OFS (temp offset) - 0 default setting (not sure what this does)
SF - not sure I got to this one yet.

Thanks guys!


Offline yso191

  • Brewmaster
  • *****
  • Posts: 632
  • Yakima, WA
    • View Profile
Re: recommended Settings for a digital therm controller
« Reply #1 on: June 05, 2013, 09:26:24 AM »
SP - set mine to 42
Dif - 3
ASD - 10
OFS (temp offset) - 0 default setting (not sure what this does)
SF - not sure I got to this one yet.


I also have mine set to 42*

'SF' means Sensor failure, I set this to 0 (which = off)
'OFS' I have set to 0 (only applies to BIN operation)
'Asd' I have set to 1  (short cycle delay)
'diF' I have set to 1 (the cut in/cut out from the setpoint)  This keeps the temperature from fluctuating too wildly.

Hope that helps!
Steve