General Category > Equipment and Software

Yet another keezer question

(1/1)

tfrommer:
Been doing my due diligence scouring all the posts here and elsewhere on chest freezer conversions as it's my summer I'm-not-handy project. Pretty much ready to go buy lumber and stain. I'm still debating whether to attach the collar to the freezer or to the lid, but my question is on a different, related topic.

What are benefits to two collars? I've seen some posts about inner and outer ones but having two just seems like 2x the ways for me to eff something up.

thanks,
Tim F.

theDarkSide:
My inner collar is the exact dimensions of the freezer opening and the outer collar hangs down around 3 sides.  Advantages for me are it helps secure the collar to the freezer and give me a place to screw in a drip tray if I want.

Also, it allows you to choose a nicer piece of wood as a facing, instead of using really expensive wood for the inside, where no one sees it anyways.

This isn't mine but it demonstrates what the outer collar does on my kegerator


Just make sure your collar is big enough so you have the clearance if you want to put kegs on the compressor hump.  Otherwise you'll have to build one all over again (ask me how I know  ::) )

kylekohlmorgen:

--- Quote from: theDarkSide on August 01, 2013, 12:20:32 PM ---Just make sure your collar is big enough so you have the clearance if you want to put kegs on the compressor hump.  Otherwise you'll have to build one all over again (ask me how I know  ::) )

--- End quote ---

^ Yep. But I think I'm just going to invest in some 2-3 gal kegs that fit.

I like the idea of the overhang - mine shifts when I lean on it (beergut gets it every time I lift a keg up and over).

My woodworking skills are excessively poor, but I could handle this project. RDWHAHB.

Navigation

[0] Message Index

Go to full version