Author Topic: Old Coolers  (Read 627 times)

Offline Joe Sr.

  • I spend way too much time on the AHA forum
  • ********
  • Posts: 2858
  • Chicago - NORTH SIDE
    • View Profile
Old Coolers
« on: December 11, 2013, 10:50:43 AM »
One of these days, I'm going to get around to building my mash tun.  I bought a round cooler, but have also acquired some larger rectangular coolers.  These are used coolers of indeterminate age.  Coleman Polylite 48, IIRC.

Any concerns using an older cooler?  One of them has some stains on the inside, but I can bleach the bejesus out of it.

Also got a newer cooler that has no drain.  I could bore through with a spade bit, but the other coolers seem ideal as long as there's no concerns about the older plastic or anything like that.
It's all in the reflexes. - Jack Burton

Offline Steve in TX

  • I spend way too much time on the AHA forum
  • ********
  • Posts: 2802
    • View Profile
Re: Old Coolers
« Reply #1 on: December 11, 2013, 10:54:39 AM »
I built my smaller tun about 6 years ago out of a cooler that was already 8 years old. I gave it a good scrubbing with 1:1 oxyclean:water. That cooler laying around + Denny's site made me jump into all-grain.
Vote Jonathan Fuller for AHA Governing Committee. For every yes vote, Jonathan will send you a can of Heady Topper.

*** This message has not been approved by Jonathan Fuller. All claims of free Heady Topper are in jest and not to be taken seriously. But seriously, he is a great brewer that is 100% committed to helping the AHA and all homebrewers prosper.

Offline beersk

  • Brewmaster General
  • *******
  • Posts: 2165
  • In the night!
    • View Profile
Re: Old Coolers
« Reply #2 on: December 11, 2013, 11:47:26 AM »
I wouldn't think there'd be any issue with older coolers. Unless you used them for fish or something (which would be weird).
Watch out for those Cross Dressing Amateurs!

Jesse

Online kramerog

  • Senior Brewmaster
  • ******
  • Posts: 1028
    • View Profile
Re: Old Coolers
« Reply #3 on: December 11, 2013, 01:19:47 PM »
I'm not aware of any problems with older coolers.  Getting a good seal for your drain is a pain if you have to alter the cooler.  If you are lucky, the copper tubing and keg grease will fit perfectly through the existing drain port. My orange, round mash tun had a fairly short life span before it started cracking.
Brewers of South Suburbia
Brixie's Brewers
Oak Park Homebrewers

Offline Joe Sr.

  • I spend way too much time on the AHA forum
  • ********
  • Posts: 2858
  • Chicago - NORTH SIDE
    • View Profile
Re: Old Coolers
« Reply #4 on: December 11, 2013, 01:51:23 PM »
I'm not aware of any problems with older coolers.  Getting a good seal for your drain is a pain if you have to alter the cooler.  If you are lucky, the copper tubing and keg grease will fit perfectly through the existing drain port. My orange, round mash tun had a fairly short life span before it started cracking.

One of the coolers came missing a drain port.  A mini-keg bung fits perfectly.  And a 1/2" barbed shank fits perfectly in those, so I should be good on rigging up a line to drain it.
It's all in the reflexes. - Jack Burton

Offline Steve in TX

  • I spend way too much time on the AHA forum
  • ********
  • Posts: 2802
    • View Profile
Re: Old Coolers
« Reply #5 on: December 11, 2013, 04:33:19 PM »
I think you should just go for it.

One thing I recommend, leak test it with hot water. My first tun held cold water fine, then dripped sticky wort when hot.
Vote Jonathan Fuller for AHA Governing Committee. For every yes vote, Jonathan will send you a can of Heady Topper.

*** This message has not been approved by Jonathan Fuller. All claims of free Heady Topper are in jest and not to be taken seriously. But seriously, he is a great brewer that is 100% committed to helping the AHA and all homebrewers prosper.

Online HoosierBrew

  • Official Poobah of No Life.
  • *
  • Posts: 5563
  • Indianapolis,IN
    • View Profile
Re: Old Coolers
« Reply #6 on: December 11, 2013, 04:42:08 PM »


One thing I recommend, leak test it with hot water. My first tun held cold water fine, then dripped sticky wort when hot.

+1.  Happened to me before too.
Jon H.

Offline duboman

  • Senior Brewmaster
  • ******
  • Posts: 1187
    • View Profile
Re: Old Coolers
« Reply #7 on: December 11, 2013, 06:31:17 PM »
Everything that comes out of the cooler is boiled anyways so if infection or associated are your concerns, personally I would have none.

As long is it holds temp and doesn't leak I would say go for it! Oh, and I'll assume they're blue:D
Peace....Love......Beer......

The Commune Brewing Company-Perfecting the craft of beer since 2010

Offline Joe Sr.

  • I spend way too much time on the AHA forum
  • ********
  • Posts: 2858
  • Chicago - NORTH SIDE
    • View Profile
Re: Old Coolers
« Reply #8 on: December 11, 2013, 08:25:41 PM »
The round one is blue. One of the old ones has faded to a greyish former blue.
It's all in the reflexes. - Jack Burton