Author Topic: Turbid mash efficiency - how to account for starch?  (Read 790 times)

Offline erockrph

  • Official Poobah of No Life.
  • *
  • Posts: 6229
  • Chepachet, RI
    • View Profile
    • The Hop WHisperer
Turbid mash efficiency - how to account for starch?
« on: December 20, 2013, 03:07:31 AM »
Since one of the purposes of a turbid mash is to leave a bunch of starch behind for Brett to chew on during the long lambic fermentation, I was wondering how you account for this as far as how much contributes to the ABV of the finished brew. I would expect your OG to be low since you still have a lot of unconverted starch. But if you're still expecting Brett to ferment the starch, then your final ABV would be higher than predicted by your OG, right?

The reason I'm asking is because I brewed a batch of lambic wort yesterday. I didn't do a turbid mash, but I tried to approximate it by doing a short, high-temp mash on the pilsner malt portion of the grain bill. Then I did a separate steep using torrified wheat in place of unmalted wheat. I raised the temp on the steeped wort to the mid 190's, then ran off my mashed pilsner wort into it to hit mashout temps pretty much instantly. The goal is a starchy, dextrinous lambic wort without going through the whole turbid mash process.

So the one thing I didn't consider when I formulated the recipe was that I was going to have a super low OG because none of the wheat would be converted. I ended up with an OG of 1.027, which is pretty much right on the money if I hit my expected efficiency from the mashed pilsner malt, but got no contribution from the torrified wheat.

Now I'm starting to wonder whether I should add some DME to add a few gravity points, or if I should let it ride. I was shooting for the 4.5-5.5% ABV range. If I get about 50% "efficiency" from the starch from the steeped wheat then I'd be close enough to the ballpark I'm shooting for. Any thoughts?

Eric B.

Finally got around to starting a homebrewing blog: The Hop Whisperer

Offline Stevie

  • Official Poobah of No Life.
  • *
  • Posts: 6858
    • View Profile
Re: Turbid mash efficiency - how to account for starch?
« Reply #1 on: December 20, 2013, 03:48:39 AM »
Total shot in the dark here, but wouldn't the dissolved starches increase the og? Maybe not the same as sugars.

Offline kylekohlmorgen

  • Senior Brewmaster
  • ******
  • Posts: 1363
  • Saint Louis, MO
    • View Profile
    • The South House Pilot Brewery
Re: Turbid mash efficiency - how to account for starch?
« Reply #2 on: December 20, 2013, 02:26:05 PM »
I've only done it a few times, but I was in the 50% mash efficiency range (63% normally).

If you need gravity, go with a mix of DME and maltodextrin as an attempt to mimic the starch/sugar profile. If you want some additional starch in the mix, steep some oats before starting the boil.

You can also increase boil-off, but I'd rather not short the volume.
Twitter/Instagram: @southhousebrew

Recipes, Brett/Bacteria Experiments: