[1vertical]

Well, I put this over in the wood/cask section because it
also fits there. But I thought it could go here as well because
It is something I made that works actually quite well.
Gives new meaning to the lyrics "Roll out the barrels"



Tall enough to rack in to corney kegs, and tall enough to be a pain to
get fresh beer back into...

[bob]

You can use CO2 to push the beer out. 2-8psi will get it up at least 6' from my experience. That way the barrel can be closer to the ground, less of a tip hazard!
Bob

[1vertical]

It is sturdy for sure made outta 2X6 ers...not thinkin it is gonna tip easily.

[dhacker]

 . .assuming it's physically anchored to the moving dolly.

[1vertical]

. .assuming it's physically anchored to the moving dolly.

Yes I put long lag screws up thru each "leg" physically anchoring it to the dolly.

[dhacker]

Then it's not going anywhere . . I like it! 

[1vertical]

Plus where every leg meets the dolly, I put hurricane angle clips to further reinforce
the stress and strain of rolling an elevated 100# of beer ( its actually150# beer + Barrel)