[flbrewer]

I noticed yesterday that an area of my false bottom is showing signs of rust (inside some of the small holes). What is the best way to remove this? I assume soaking in some Starsan as the holes are very small.

[hopfenundmalz]

Barkeeper's Friend is good, but it might be hard to get in the holes. Try a past and let is set for a while, then clean off, let it air dry and the O2 in the air will passivate it .

[Wort-H.O.G.]

I noticed yesterday that an area of my false bottom is showing signs of rust (inside some of the small holes). What is the best way to remove this? I assume soaking in some Starsan as the holes are very small.

probably made in china, so you're likely screwed. should be stainless steel and made in the good ol' USA.

[flbrewer]

I noticed yesterday that an area of my false bottom is showing signs of rust (inside some of the small holes). What is the best way to remove this? I assume soaking in some Starsan as the holes are very small.

probably made in china, so you're likely screwed. should be stainless steel and made in the good ol' USA.

It's 304...no clue where it's made.

[flbrewer]

A couple pics...good ole' MoreBeer is shipping me a new one tomorrow.