Had my old fermentation chamber die, so I decided to go a new route and built something a little different. I had been running a single brewpi, but with the new setup I wanted independent controls for each fermenter. I started with the addition of these:

Then I bought a few of these from amazon for cheap:

Against my wifes dismay, I did what any normal person would do and strip it down and cut a giant rectangle out of the door.

Then I went to Home Depot and picked up some supplies..FRP edging, some silicone and a couple sheets of plexi. I then trimmed out the door with the FRP edging:

I then installed the plexi(double sealed panes), which fits perfectly in the FRP edging:

Started installing the LED lighting, mini hair dryer for heating, a fan to circulate air, and the temp probes, did a test fit midway though:

With the lights out:

Then I built its clone:

Lights out

They fit nicely into "The Cellar"

Which fits nicely into "The Beerery"

Cheers!