Author Topic: converted keggle voltage question  (Read 1023 times)

Offline andylovesburritos

  • Cellarman
  • **
  • Posts: 26
converted keggle voltage question
« on: May 04, 2015, 09:01:28 am »
i have a converted keggle that i have been using a propane burner on, but due to new equipment and a new brewing garage with size limitations, i want to convert my HLT to electric. i found a few conversion kits online to do just that, but i was wondering if i can use 120 volts or do i need 240 instead for brewing 10 gallon batches?

Offline ccfoo242

  • Brewmaster
  • *****
  • Posts: 808
  • I drank what? - Socrates
Re: converted keggle voltage question
« Reply #1 on: May 07, 2015, 09:21:06 am »
Definitely 240v for 10 gallons. I found the electric brewing section of homebrewtalk.com has lots of information.
Intra cervisiam est deus.

S. cerevisiae

  • Guest
Re: converted keggle voltage question
« Reply #2 on: May 08, 2015, 11:00:01 am »
Ten gallon batches are out of the question with a 15A 120VAC line.

Offline a10t2

  • Official Poobah of No Life. (I Got Ban Hammered by Drew)
  • *********
  • Posts: 4696
  • Ask me why I don't like Chico!
    • SeanTerrill.com
Re: converted keggle voltage question
« Reply #3 on: May 09, 2015, 10:02:07 am »
You certainly *could* do it. It's just a question of whether you're willing to schedule your brew day around it. Under ideal conditions, an 1800 W element would heat 15 gal to strike temperatures in about two hours, take an hour to get from lauter to a boil, and boil off ~0.7 gal/hr once at a boil.

I use a 120 V element for my hot liquor, and just set it to turn on a couple hours before I want to brew using an outlet timer. The timer controls a relay since I doubt the little plastic box could handle 15 A.
« Last Edit: May 09, 2015, 10:04:40 am by a10t2 »
Sent from my Microsoft Bob

Beer is like porn. You can buy it, but it's more fun to make your own.
Refractometer Calculator | Batch Sparging Calculator | Two Mile Brewing Co.

Offline andylovesburritos

  • Cellarman
  • **
  • Posts: 26
Re: converted keggle voltage question
« Reply #4 on: May 14, 2015, 12:17:14 pm »
thanks everyone, i went the 240 volt route.