General Category > Kegging and Bottling

Ball Lock Out Disconnect Broken ?

(1/1)

ndcube:
Somehow* the black plastic seal at the end of the threads got a nic  in it.  I connected it to a gas line and put it in some water and sure enough that's where it's leaking.

Can that piece be repaired / replaced or am I out the cost of a disconnect?

*I dropped it.  :'(

bluesman:
Aside from alot of teflon tape I'm not certain you will be able to cure that one. I think you can pick another one up for about ten bucks or so.  :-\

wilypig:
Kegworks.com used to have them for 6.99

Navigation

[0] Message Index

Go to full version