Membership questions? Log in issues? Email info@brewersassociation.org

« previous next »
Pages: [1]   Go Down

Author Topic: Pump Mount  (Read 1518 times)

Offline narcout

  • Brewmaster General
  • *******
  • Posts: 2217
  • Los Angeles, CA
Pump Mount
« on: July 03, 2017, 12:17:39 pm »
I've been waiting to come across a good piece of scrap wood on which to mount my pump and power strip. 

Earlier this week, I found a piece of butcher block that was bolted onto a kitchen cart someone was throwing out.



I might attach some rubber feet, but this should keep everything level for now and out of any liquid that might be on the floor.
Logged
Sometimes you just can't get enough - JAMC

Offline denny

  • Administrator
  • Retired with too much time on my hands
  • *****
  • Posts: 27129
  • Noti OR [1991.4, 287.6deg] AR
    • Dennybrew
Re: Pump Mount
« Reply #1 on: July 03, 2017, 12:20:47 pm »
WAY nicer than the hunk of 2x4 I use!
Logged
Life begins at 60.....1.060, that is!

www.dennybrew.com

The best, sharpest, funniest, weirdest and most knowledgable minds in home brewing contribute on the AHA forum. - Alewyfe

"The whole problem with the world is that fools and fanatics are always so certain of themselves, and wiser people so full of doubts." - Bertrand Russell

Offline Stevie

  • Official Poobah of No Life. (I Got Ban Hammered by Drew)
  • *********
  • Posts: 6858
Re: Pump Mount
« Reply #2 on: July 03, 2017, 12:25:33 pm »
Nice. I used three pieces of flooring samples from Home Depot for mine. Added rubber feet. It's a bit top heavy and tips when I tug the lines, but it works for now.
Logged

Big Monk

  • Guest
Pump Mount
« Reply #3 on: July 03, 2017, 03:58:05 pm »
One of the advantages of a small pump:

Logged
Pages: [1]   Go Up
« previous next »