Membership questions? Log in issues? Email info@brewersassociation.org

« previous next »
Pages: [1]   Go Down

Author Topic: Nylon Washer Question  (Read 975 times)

Offline Bo Buck Brewery

  • 1st Kit
  • *
  • Posts: 5
Nylon Washer Question
« on: May 18, 2018, 05:24:27 pm »
This is my 2nd keezer build and this go around I'm using all MFL fittings on CO2 lines and beer lines.  Do I need nylon washers on the beer lines too?
Logged

Offline Joe Sr.

  • Official Poobah of No Life. (I Got Ban Hammered by Drew)
  • *********
  • Posts: 4467
  • Chicago - NORTH SIDE
Re: Nylon Washer Question
« Reply #1 on: May 18, 2018, 05:29:41 pm »
I think you only need nylon washers on steel to steel MFLs.  The QDs I have already have a plastic end, so they don't need the nylon washer.  Metal to metal will leak without.
Logged
It's all in the reflexes. - Jack Burton

Offline Bo Buck Brewery

  • 1st Kit
  • *
  • Posts: 5
Re: Nylon Washer Question
« Reply #2 on: May 18, 2018, 05:40:18 pm »
Excellent point.  I will put them on the metal to metal connections.
Logged
Pages: [1]   Go Up
« previous next »