Author Topic: Spunding effect on re-pitched yeast  (Read 427 times)

Offline mainebrewer

  • Brewer
  • ****
  • Posts: 495
  • Palermo, Maine
Spunding effect on re-pitched yeast
« on: August 07, 2018, 12:41:06 AM »
A few months ago I started transferring my fermenting beer into a purged keg with 3-4 to go before reaching a predicted FG. I re-pitch my harvested yeast 8-10 times. Since by transferring before FG is reached and harvesting the yeast that has dropped out of suspension at that point, I am selecting yeast that has flocculated early. My questions: am I likely to see any change in behavior from the yeast I am harvesting early, ie: yeast dropping out of suspension earlier and earlier ? Or is this something that would only be an issue with many more re-pitches.
BJCP Certified

Offline ynotbrusum

  • Official Poobah of No Life.
  • *
  • Posts: 3213
Re: Spunding effect on re-pitched yeast
« Reply #1 on: August 07, 2018, 11:32:46 AM »
While it seems logical to reach that conclusion, I highly doubt it, based on my experience with non-spunded repitching.  Several years ago, I took a lager yeast out to 25 successive batches without issue (over 2.5 years).  I didn’t have the spunding aspect in my situation, but I wouldn’t conclude from your situation that the yeast that you harvest have less vitality, just because of floccing out before the final points are dropped - however, if you also were fermenting under pressure for the full primary fermentation, then my conclusion would differ, as the pressure should have some affect on vitality and suppressive effects, generally.  I would expect some potential for genetic drift in a pressurized fermentation set up, less so with mere harvesting than spunding.

But, try it out and let us know your results!
Hodge Garage Brewing: "Brew with a glad heart!"

Offline slickfish1

  • 1st Kit
  • *
  • Posts: 4
Re: Spunding effect on re-pitched yeast
« Reply #2 on: August 07, 2018, 11:42:24 AM »
I suspected this very thing a while back due to very slow finishes on the last 4 to 6 gravity points. It turns out that it was due to having too much residual sulfite after oxygenating. I was at 30 ppm and have since reduced to 10 and that solved the problem.


Sent from my iPhone using Tapatalk

Offline mainebrewer

  • Brewer
  • ****
  • Posts: 495
  • Palermo, Maine
Re: Spunding effect on re-pitched yeast
« Reply #3 on: August 08, 2018, 10:38:06 AM »
Well, I haven't had any issues, so far, with re-using the yeast that I have collected at the time I spunded. It does seem logical that if I continually select yeast that floc before FG is reached, that at some point a majority of the yeast cells would floc before FG is reached. Perhaps that change would take hundreds of re-pitches and I'll never see any change in the limited number of re-pitches that I normally do. Mostly just curious what other brewers thought about it.
BJCP Certified