General Category > Equipment and Software

Sight Gauge

(1/8) > >>

pitbull:
Looking to add a sight gauge to my boil tun. It's a converted keg. Any suggestions on where to buy and mount?

oscarvan:
After exhaustive research I found the best deal HERE.

So far so good.

phillamb168:

--- Quote from: oscarvan on January 18, 2011, 10:47:11 PM ---After exhaustive research I found the best deal HERE.

So far so good.



--- End quote ---

Did you buy this? If so, how'd you like it? Unfortunately they don't ship internationally ("too much paperwork" is always a super lame excuse in my opinion) so before I have it shipped twice (to my dad, then he sends it to me) I wanna make sure it's a good solution. Does it seem like it'd fit any size kettle? I'd probably order the sight glass/thermometer combo, as it seems neat.

Mark G:

--- Quote from: phillamb168 on January 19, 2011, 12:12:51 AM ---
--- Quote from: oscarvan on January 18, 2011, 10:47:11 PM ---After exhaustive research I found the best deal HERE.

So far so good.



--- End quote ---

Did you buy this? If so, how'd you like it? Unfortunately they don't ship internationally ("too much paperwork" is always a super lame excuse in my opinion) so before I have it shipped twice (to my dad, then he sends it to me) I wanna make sure it's a good solution. Does it seem like it'd fit any size kettle? I'd probably order the sight glass/thermometer combo, as it seems neat.

--- End quote ---
I have two of these, one for a converted keg and one for a 10 gal kettle. Both fit great and are top notch quality.

oscarvan:
Yup, bought it. Good craftsmanship, good materials. Great deal.

Navigation

[0] Message Index

[#] Next page

Go to full version