Membership questions? Log in issues? Email info@brewersassociation.org

Author Topic: Brewing Salts Content of Briess DME/LME  (Read 1833 times)

Offline tomsawyer

  • Senior Brewmaster
  • ******
  • Posts: 1694
Brewing Salts Content of Briess DME/LME
« on: January 24, 2011, 02:50:10 pm »
This came up recently in a discussion of extract brewing and water treatment.  No one seemed to have the answer offhand so I emailed Briess and asked the question.  They were kind enough to reply with the following information:

"We do not regularly test our products for these salts, but we do
occasionally test the water used in our mash. Sulfate is around 63mg/L
and Chloride around 28 mg/L. Since we produce 16 Plato wort (Gravity
1.064), you can calculate that for every 1 Plato increase (Gravity .004)
from extract you use you will be adding approximately SO4=4mg/L and
Cl=1.8mg/L to your brew. The water that we use is of moderate hardness,
but since we make high gravity brews, the hardness will be lower if you
brew a beer below 1.064 using distilled water."

I thought this was good information and wanted to share.
Lennie
Hannibal, MO

Offline denny

  • Administrator
  • Retired with too much time on my hands
  • *****
  • Posts: 27093
  • Noti OR [1991.4, 287.6deg] AR
    • Dennybrew
Re: Brewing Salts Content of Briess DME/LME
« Reply #1 on: January 24, 2011, 02:53:15 pm »
Thanks, Lennie.  That's good info, and kudos to Briess for sharing it.
Life begins at 60.....1.060, that is!

www.dennybrew.com

The best, sharpest, funniest, weirdest and most knowledgable minds in home brewing contribute on the AHA forum. - Alewyfe

"The whole problem with the world is that fools and fanatics are always so certain of themselves, and wiser people so full of doubts." - Bertrand Russell

Offline tomsawyer

  • Senior Brewmaster
  • ******
  • Posts: 1694
Re: Brewing Salts Content of Briess DME/LME
« Reply #2 on: January 24, 2011, 05:04:25 pm »
Yes I was somewhat surprised that they replied.  I did tell them it was for a conversation that was going on at the AHA forum.

The level of the flavor anions favors hoppy brews but the levels are so modest as to not really affect the outcome significantly.  You can easily add chloride and convert to a malty flavor profile without raising the chloride level to high.  And thats at 1.064, bring it down to a 1.050 and you are in a very nice place.  The moderate hardness isn't necessarily good for a pils style.  I'd definitely use distilled water for something along those lines, and probably make the OG in the mid to high 40's.
Lennie
Hannibal, MO