Membership questions? Log in issues? Email info@brewersassociation.org

Author Topic: dissolving chalk  (Read 2752 times)

Offline jimrod

  • Assistant Brewer
  • ***
  • Posts: 181
dissolving chalk
« on: June 10, 2011, 01:59:44 am »
Do I have to use co2 to dissolve the chalk for building my water? How do you add chalk?
The liver is evil and must be punished

Offline tygo

  • I spend way too much time on the AHA forum
  • ********
  • Posts: 2622
  • Sterling, VA
Re: dissolving chalk
« Reply #1 on: June 10, 2011, 04:40:45 am »
Clint
Wort Hogs

Offline mabrungard

  • I spend way too much time on the AHA forum
  • ********
  • Posts: 2902
  • Water matters!
    • Bru'n Water
Re: dissolving chalk
« Reply #2 on: June 10, 2011, 07:01:58 am »
The carbonator cap method that is shown on Kai's website is a good way to go.  You can dissolve a lot of chalk into a volume of water that way. 

One thing that the website mentions that you shouldn't do is add chalk (or any alkalinity source) to sparging water.  Sparging water MUST have low alkalinity to reduce the potential for leaching tannins from the grist.  We use pH goals for sparging water, but that is just an indirect indicator of alkalinity reduction that is the real result.  If you use RO or distilled water, you don't have to adjust its pH for use as sparging water since its alkalinity is already low. 
   
Martin B
Carmel, IN

BJCP National
Foam Blowers of Indiana (FBI)

Brewing Water Information at:
https://www.brunwater.com/

Like Bru'n Water on Facebook
https://www.facebook.com/Brun-Water-464551136933908/?ref=bookmarks

Offline 1vertical

  • I spend way too much time on the AHA forum
  • ********
  • Posts: 2702
  • Ozone Layer. Actual location
Re: dissolving chalk
« Reply #3 on: June 11, 2011, 10:52:35 pm »
I use either a keg or a liter soda bottle full of 1/2 gallon of distilled or DI water
and charge it up with lots of CO2 gas to get the carbonic acid happening.
of course I add the chalk to the water first then the gas....makes for good
results dissolving that material.  Into the mash water that saturated solution goes
A fine is a tax for doing wrong. A tax is a fine for doing well.

Offline mabrungard

  • I spend way too much time on the AHA forum
  • ********
  • Posts: 2902
  • Water matters!
    • Bru'n Water
Re: dissolving chalk
« Reply #4 on: June 12, 2011, 06:16:06 am »
By the way when properly dissolving chalk in carbonated water,  the full alkalinity of the chalk is obtained.  To my knowledge, only Palmer's sheet and Bru'n Water calculate the correct amount of bicarbonate added to the water under this condition. Most water calculators calculate roughly half the actual alkalinity that is provided by the fully dissolved chalk.  That half number is a decent approximation of the bicarbonate increase when the chalk isn't fully dissolved. 
Martin B
Carmel, IN

BJCP National
Foam Blowers of Indiana (FBI)

Brewing Water Information at:
https://www.brunwater.com/

Like Bru'n Water on Facebook
https://www.facebook.com/Brun-Water-464551136933908/?ref=bookmarks