Author Topic: Woodworking  (Read 2202 times)

Offline phillamb168

  • Brewmaster General
  • *******
  • Posts: 2351
  • Lardy, France
    • My Job
Re: Woodworking
« Reply #15 on: September 27, 2011, 09:26:59 AM »
One thing you can do is build the cabinets yourself, because they aren't that hard to build and they don't require super equipment or special bits. Then get with a cabinet maker for your door and drawer fronts.

That sounds pretty reasonable. And plus we can make do with cabinets with no fronts for a while if need be.. hrm...

Is crown molding easier to make than cabinet fronts?
I'm on twitter: phillamb168
----
morticaixavier for governing committee!

Offline MDixon

  • Brewmaster General
  • *******
  • Posts: 2155
Re: Woodworking
« Reply #16 on: September 27, 2011, 12:47:59 PM »
I would never attempt to make crown, think about the profile you're after. IMO, better to purchase and install. Most carpenters don't make their own trims. It's one thing to use a router or router table on an edge and quite another to make mouldings.
It's not a popularity contest, it's beer!