I recently switched from a single regular to a double so I could use a Blichmann beer gun. I installed a spitter on one side to accommodate it. Ever since I've done this I have a slow leak that I can't find. I am hoping someone here can verify or correct me on how I am connection everything. I am going to go through every connection.
1) CO2 to regulator: I have the taprite flat seal but do I need some type or washer in between? (I am fully aware that the washer is not installed correctly. My question assumes it will be installed correctly)
2) Gas out connections (See picture below)
A- This is attached to a gas line with a threaded adapter. I seal with pipe tape and a 1/4" flare washer (pictured below). Is that correct?
B- I seal with strictly pipe tape. Is that correct?
C-I seal the top ones with pipe tape and the flare washers (pictured below). Is that correct? The bottom is attached to a gas line with a threaded adapter. I seal with pipe tape and a 1/4" flare washer (pictured below). Is that correct?
Flare washers mentioned above.